DIY Frame Parts

For a limited time we are providing for purchase some of the key components you’ll probably need in building your frame. Each of these should save you significant time.

This 16 Gb USB 3.0 drive and 4 Gb  Mirco SD card were selected by our team as optimal for frame-building and come with our software pre-installed on them. With these you won’t have to spend time researching memory or downloading and writing the Canviz software to them.

USB & SD Memory w/ Software Pre-installed

 Cost: $40




The Raspberry Pi B+ can be hard to find, and expensive, so we’re making them available (to frame-builders only please!).

Raspberry Pi B+

 Cost: $38




Our frames are specifically made for 21.5″ LCD panels. These are 1.75″ deep, include a plastic part to hold an LCD in place, a frame backing, mounts for hanging the frame, screws for assembling and hanging as well as drywall anchors (for hanging).

Black Canviz Framing w/ additional hardware

 Cost: $75




Our frames are specifically made for 21.5″ LCD panels. These are 1.75″ deep, include a plastic part to hold an LCD in place, a frame backing, mounts for hanging the frame, screws for assembling and hanging as well as drywall anchors (for hanging).

Natural Wood Canviz Framing w/ additional hardware

 Cost: $75




We’ve bundled a few cables and an adapter you’ll probably need. The cables are all short-length and high-quality, selected by our team for frame-building, and include:

  • 1  USB-B->USB-A cable
  • 1  HDMI cable
  • 1  Micro-USB power cable
  • 1  HDMI->DVI adapter

Cables (3) & Display Adapter

 Cost: $40




Creative Commons License
Canviz designs, software and instructions are licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.